Yamaha DTX700 - Manual (Page 59)

FILE
DTX700 Reference Manual 59
Carry out the following steps to load a file saved on
a USB memory device into the DTX700.
 Procedure
1. Plug the USB memory device containing the saved file
into the [USB TO DEVICE] port on the side panel.
2.
Navigate to the Menu area’s File/Load page.
The page will appear as follows.
3.
Select the file type.
Move the cursor to the Type row, press the dial, and select
the type of file you wish to load.
The supported types are as follows.
Settings: All, AllKit, Kit, AllWave, Wave, AllSong, Song, All-
Trigger, Trigger, Utility
4. Select the file you wish to load.
Move the cursor to the File row, and then select the file to
be loaded by turning the dial or pressing the [-/DEC] and
[+/INC] buttons. Only those files matching your selected
file type will be presented for loading. If you have opted to
load a single file, you will first of all need to select the All
file that contains it (for example, when loading a single
User kit, you first select a file saved with the type
“AllKit”). It is not, however, possible to load a single file
when an All type has been selected for loading.
5. When you have selected the file to be loaded, press the
[F3] button.
Case 1: If “All”, “AllKit”, “AllWave”, “AllSong”, “All-
Trigger”, or “Utility” was selected:
Press the [F3] button (EXECUTE) and proceed to
Step 7.
Case 2: If “Kit”, “Wave”, “Song”, or “Trigger” was
selected:
Press the [F3] button (NEXT >>) and proceed to
Step 6.
6.
Select the required package of data from inside the
selected file.
6-1 Move the cursor to Src or Dst and press the dial.
Src indicates the file that will be loaded (i.e., the
source), and Dst indicates where it will be saved
within the DTX700 (i.e., the destination).
6-2 Turn the dial or press the [-/DEC] and [+/INC] but-
tons to select the file you wish to load and the num-
ber of the User kit, User wave, User song, or User
trigger to be overwritten.
6-3 When you have set either Src or Dst, press the dial
once again.
When loading a kit:
Settings: 01 to 60
When loading a wave:
Settings: 001 to 500
When loading a song:
Settings: Src 01 to 98, Dst 01 to 93
NOTE
• Src = 98 corresponds to data recorded by press-
ing the [REC] button.
FILE/LOAD
All
All User data – i.e., all User kits, User
waves, User songs, and User triggers in
addition to utility data
AllKit All User kit data
Kit A single User kit
AllWave All wave data
Wave A single User wave
AllSong All User song data
Song A single User song
AllTrigger All User-trigger data
Trigger A single User trigger setup
Utility Utility data