Zoom G1U - Manual (Page 10)

18 ZOOM G1u 19 ZOOM G1u
Using a Foot Switch or Pedal
• Edit mode/Store mode
The foot switch has no effect.
Using an expression pedal
When the optional expression pedal (FP01/
FP02) is connected to the [CONTROL IN]
jack of the G1u, you can change effect
parameters in real time or use the pedal as a
volume controller. The function of the
expression pedal can be saved individually for
each patch.
1. Plug the FP01/FP02 into the
[CONTROL IN] jack.
2. In play mode, select a patch for
which you want to use the expression
pedal.
3. Set the Module selector to a position
other than "PLAY" or "RHYTHM".
The G1u goes into edit mode.
4. Hold down the RHYTHM [
R
/
P
] key
and turn the [VALUE] knob to select
one of the following modules for
control by the expression pedal.
Display Control target
OF Off
VP Volume
WP COMP/EFX module
GP DRIVE module
MP MODULATION module
DP DELAY module
RP REVERB module
· In the section "Effect Types and
Parameters" (g p. 21), effect types/
parameters that can be controlled with
the expression pedal are indicated by a
pedal symbol.
· If a module is selected for which no
pedal symbol is shown, the expression
pedal will have no effect for that patch.
5. Save the patch.
The expression pedal setting is stored with
the patch.
6. In play mode, select the patch and
operate the expression pedal.
The respective parameter changes.
In bypass mode, the expression pedal
always functions as a volume pedal,
regardless of the setting.
The expression pedal operates also in edit
mode.
Changing the Way Patches Are Called Up
This section describes how to change the patch selection method of the G1u to "pre-select". In this
mode, you first select the patch to use next, and then perform an additional step to activate the
patch.
1. Turn power to the G1u on while
holding down the [Q] foot switch.
The indication "PrE-SElEct" scrolls on the
display.
2. In play mode, select the patch to use
next.
The selected new bank and patch number
flash on the display. The sound does not
change yet.
3. When you have specified the patch to
use, press both [
W
]/[
Q
] foot switches
together.
The patch change is accepted, causing the
sound to change, and the display changes
from flashing to permanently lit.
4. To return the G1u to the normal patch
selection method, simply turn power
off and then on again.
The patch selection method is automatically
reset to conventional operation.
Using a Foot Switch or Pedal
This section explains how to use an optional foot switch or expression pedal.
Using a foot switch
When an optional foot switch (FS01) is
connected to the [CONTROL IN] jack of the
G1u, you can switch banks and specify the
tempo for rhythm patterns with the foot switch.
Depending on the currently selected mode, the
foot switch operates as follows.
• Play mode
Pressing the foot switch selects the next
higher bank.
• Rhythm mode/Looping mode
When you press the foot switch two times or
more, the G1u detects the interval and
automatically adjusts the tempo accordingly
(tap tempo function).
B0 B0
B 0
HINT
HINT
B0 B0