Zenoah MISTER MD6210M - Manual (Page 11)

MD6210M
GB-11
G
B
6. Set up
FLEXIBLE HOSE and SWIVEL JOINT
1. Connect the blower and swivel joint with flexible hose.
Clamp both ends of the flexible hose securely with
the hardware supplied with the unit. Fix the clamp
(small) with the intermediate valve.
(5)
(4)
(3) (1) (4) (2)
(1) Flexible hose
(2) Swivel joint
(3) Clamp (Large)
(4) Clamp (Small)
(5) Intermediate valve (fixed with clamb (small))
NOTE
A light lubricant may be used to ease assembly of
flexible pipe to blower elbow.
CONTROL HANDLE
• Set up the handle holder to the swivel joint and tighten
the screw on the handle holder. Use the clamp to fas-
ten the solution pipe to the pipe.
(3) (1)
(4)
(2)
(4)
(1) Handle holder
(2) Swivel joint
(3) Screw
(4) Clamp
BEND PIPE AND MIST NOZZLE
• Connect the swivel joint and bend pipe. Push the pipes
together and turn them so they lock in relation to one
another until the connection is locked. Connect the
mist nozzle to the bend pipe.
(1)
(2)
(2)
(3)
(1) Swivel joint
(2) Bend pipe
(3) Mist nozzle
SOLUTION TUBE
• Route the solution tube from material tank to the mist
nozzle.