Zebra Technologies TLP 3844-Z - Manual (Page 41)

Replacing the TLP Print Head (Continued)
Assembly
The new print head comes with the clip
and ground screw attached.
1. Align the print head and bracket to
plug the left and right connectors into
the black and white wire bundles.
2. Attach the ground wire and secure it
with the screw. Use a #2 Phillips
driver to tighten it.
3. Insert the bracket pegs into the left
side of the carriage.
4. Align the right side of the bracket and
insert the print head clip through the
right side of the ribbon carriage into
the bracket.
5. Slip the left end of the print head
spring into the left side of the ribbon
carriage; then slide the right end into
the other side. The angle of the “V”
fits into the indent on top of the print
head bracket.
6. Clean the print head with the cleaning
pen.
Reload media and ribbon. Plug in the
power cord, turn on the printer and run an
automatic or manual calibration to ensure
proper function.
980441-001 Rev. A 33