Zebra Technologies TLP 3844-Z - Manual (Page 54)

Media Specifications
Width 1 to 4.25 inches / 25.4 to 108 millimeters)
Length 0.5 to 39 inches / 13 to 559 millimeters with standard memory
Gap 0.08 to 0.16 inch (2.0 to 4.0 millimeters)
0.118 inch / 3.0 millimeters recommended
Thickness 0.003 to 0.007 inch / 0.08 to 0.18 millimeter
Roll Size Maximum outer diameter: 5 inches (127 millimeters)
Inner Core diameters: 1 or 1.5 inches (25.4 or 38 millimeters)
Optional media hangers available for larger inner core
diameters
Requirements
✔ User Zebra-brand direct thermal or thermal transfer media
that is outside wound. Media may be reflective (black mark)
sensing or transmissive sensing, die-cut, notched, or
continuous)
✔ For die-cut labels, use only full auto dies.
✔ Notched media must have a 0.5 inch (13 mm) wide by 0.094
inch (2.5 mm) long cutout located in the center of the roll.
✔ The reflective media black marks must be located in the
center of the roll. Mark width 0.5 inch (13 mm) centered and
perpendicular to the edge of the media; mark length 0.094
inch (2.4 mm) parallel to the bottom edge of the media.
Always thoroughly test your desired media for your specific application
before buying in large quantities.
Ribbon Specifications for TLP model
Roll Size Maximum outer diameter: 1.3 inches / 33 millimeters
Length 2,900 inches / 74 meter capacity; provides 1:1 media roll to
ribbon ratios
Width At least as wide as media
Setup Ink-side out
Requirements User Zebra-brand ribbon that is outside wound.
46 980441-001 Rev. A