ZyXEL Communications Internet Security Gateway ZyWALL 100 - Manual (Page 260)

ZyWALL 100 Internet Security Gateway
Remote Management 24-3
Figure 24-2 Menu 24.11 – Remote Management Control
Table 24-1 Menu 24.11 – Remote Management Control
FIELD DESCRIPTION EXAMPLE
Telnet Server
FTP Server
Web Server
SNMP Service
DNS Service These read-only labels denote the kind of server that you may remotely
manage.
Server Port Change the service port number for corresponding services in this field. 23
Server Access Select the access interface (if any) by pressing [SPACE BAR], then
[ENTER] to choose from: LAN only, WAN only, ALL or Disable. LAN Only
(default)
Secured Client
IP The default value for Secured Client IP is 0.0.0.0, which means you
don’t care which host is trying to use a service (Telnet, FTP or Web).
If you enter an IP address in this field, the ZyWALL will check if the
client IP address matches the value here when a (Telnet, FTP or Web)
session is up. If it does not match, the ZyWALL will disconnect the
session immediately.
If the Server Access field is set to Disable, then this field is N/A.
0.0.0.0
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.
Menu 24.11 - Remote Management Control
TELNET Server: Port = 23 Access = LAN only
Secured Client IP = 0.0.0.0
FTP Server: Port = 21 Access = LAN only
Secured Client IP = 0.0.0.0
Web Server: Port = 80 Access = LAN only
Secured Client IP = 0.0.0.0
SNMP Service: Port = 161 Access = LAN only
Secured Client IP = 0.0.0.0
DNS Service: Port = 53 Access = LAN only
Secured Client IP = 0.0.0.0
Press ENTER to Confirm or ESC to Cancel: