Yamaha HTR-6180 - Manual (Page 72)

68
En
SIRIUS Satellite Radio™ tuning
4
Press 8k / n repeatedly to select “SIRIUS”
and then press 8
ENTER.
The following menu screen appears.
5
Press 8n repeatedly to select “PARENTAL
LOCK” and then press 8
ENTER.
“NEW PIN:0000” appears.
If a SiriusConnect tuner is not connected to this unit, “Not
Available” appears.
y
If the Parental Lock code number is already set, “PIN:___”
appears instead of “NEW PIN:0000”. Refer to step 8 and
then proceed the operations.
6
Enter the desired 4-digit code number by
using the numeric buttons (6).
y
Press 9RETURN to return the previous menu level
without setting the code number.
7
Press 8
ENTER to confirm the code number.
“OK” and then the SIRIUS Satellite Radio channel
list appears. Refer to the step 9 and then proceed the
operations.
8
Enter the 4-digit code number you set at step
6 above to unlock the protection.
When the code number is correct, “OK” and then the
SIRIUS Satellite Radio channel list appears.
9
Press 8l / h repeatedly to select the
desired channel category and then press
8k / n repeatedly to select the channel you
want to lock.
In the SIRIUS Satellite Radio channel list screen, this unit
outputs the sound of the selected channel even if the channel
is locked. Only the first eight characters of each channel
name are displayed in the list.
10
Press 8
ENTER to lock the selected
channel.
Check mark appears before the locked channel.
y
When you select the locked channel and press 8ENTER,
this unit unlocks the selected channel.
11
Repeat steps 9 and 10 to lock the channels
you want.
12
Press 9
RETURN to exit from the
“PARENTAL LOCK” screen.
13
Press I
SET MENU to exit from the setup
menu.
This unit is tuned into the last channel you select in
the “PARENTAL LOCK” screen. If the channel is
locked, this unit is tuned into “184 SIRIUS Weather
& Emergency” or “000 Sirius IDxxxxxxxxxxxx”
(“xxxxxxxxxxxx” indicates the Sirius ID of your
SiriusConnect tuner).
y
• If you forget or want to change the Parental lock code number,
use “SR PIN” in “ADVANCED SETUP” to reset the Parental
Lock code number.
• When you select “ALL” in “INIT” (see page 112), all locked
channels are unlocked.
■ Tuning into the locked channels
You can tune into the locked channels by the Direct
number access mode or preset tuning mode. When you
tune into the locked channel, following message appears
in the front panel display. Enter the code number you set
for the Parental Lock feature by using the numeric buttons
(6) or press HENT to cancel the tuning.
• If the entered code number is incorrect, “Wrong” appears in the
front panel display and this unit is tuned into the previously
selected channel.
• If a channel is unlocked, you can also select the channel in
Zone2.
Note
A) SIRIUS
. INPUT RENAME
VOL. TRIM ;;;;;0.0dB
PARENTAL LOCK
[ ]/[ ]:Up/Down
[ENTER]:Enter [ p
PARENTAL LOCK
NEW PIN:0000
[0] [9]:NUMBER
[ENT]:Enter
-
Note
Notes
PIN:____