Yamaha RX-SL100RDS - Manual (Page 14)

CONNECTIONS
12
Do not connect this unit or other components to the mains power until all connections between components are complete.
• Make sure that all connections are made correctly - that is to say, L (left) to L, R (right) to R, “+” to “+” and “–”
to “–”. Some components require different connection methods and have different jack names. Refer to the operating
instructions for each component you wish to connect to this unit.
• After you have completed all connections, check them again to make sure they are correct.
• The jack names correspond to the names on the input selector.
■ Connecting a TV
Connect one end of the SCART cable to the TV/IN OUT connector on this unit and the other end to the SCART
connector on your TV.
■ Connecting AV components
Connect one end of the SCART cable to the EXT. IN/OUT connector on this unit and the other end to the SCART
connector on your AV component. You can also daisy chain several SCART components together as shown in “Digital
audio connections” (page 13).
Use a SCART cable to make the above connections. The SCART cable, or “Euro AV cable”, supports IN/OUT signal transmission,
providing you with the best possible picture and sound.
CONNECTIONS
Before connecting components
Connecting other components
Note
CAUTION
AM ANT FM ANT
75 Ω UNBAL
OPTICAL
DVD
/CD
DTV
/CBL VIDEO 1 SUBWOOFER
FRONT
R
SURR BACK CENTER SURROUND
1 2 3
COAXIAL
GND
TUNER
EXT. IN/OUT
OUTPUT
TV IN/OUT SPEAKERS
MAINS
DIGITAL
INPUT
L R L
–
+
–
+
AV component
(DVD player, cable tuner, etc.)
TV
01EN.00_RX-SL100RDS.book Page 12 Thursday, November 27, 2003 12:42 PM