Yamaha RX-SL100RDS - Manual (Page 29)

27
English
TUNING
BA
S
IC
OPERA
T
ION
The four modes are available in this unit for displaying
RDS data. The PS, PTY, RT and/or CT mode indicators
that correspond to the RDS data services offered by the
station light up on the front panel display. Press FREQ/
RDS on the remote repeatedly to change the display mode
among the RDS data offered by the transmitting station in
the order shown below.
• Do not press FREQ/RDS until one or more RDS mode
indicators light up on the front panel display. You cannot
change the mode if you press the button prior to this. This is
because this unit has not finished receiving all of the RDS data
from the station.
• RDS data not offered by the station cannot be selected.
• This unit cannot utilize the RDS data source if the signal
received is not strong enough. In particular, the RT mode
requires a large amount of data, so it is possible that the RT
mode may not be displayed even if other RDS modes (PS, PTY,
etc.) are displayed.
• RDS data may not be received under poor reception conditions.
In such cases, press TUNING MODE so that the “AUTO”
indicator disappears from the front panel display. Although this
will change the reception mode to manual, RDS data may be
displayed when you change the display to RDS mode.
• If the signal strength is weakened by external interference
during the reception of an RDS station, the RDS data service
may be cut off suddenly and “...WAIT” will appear on the front
panel display.
If you select the desired program type, this unit
automatically searches all preset RDS stations that are
broadcasting a program of the required type.
1
Press PTY SEEK MODE to set this unit in the
PTY SEEK mode.
The program type of the station being received or
“NEWS” flashes on the front panel display.
2
Press u PRESET d to select the desired
program type.
The selected program type appears on the front panel
display.
3
Press PTY SEEK START to begin searching
all preset RDS stations.
The selected program type flashes and the “PTY
HOLD” indicator lights up on the front panel display
while searching for stations.
• The unit stops searching when it finds a station
broadcasting the selected type of program.
• If the found station is not the one you desire one,
press PTY SEEK START again. This unit resumes
searching for another station broadcasting the same
type of program.
To cancel this function
Press PTY SEEK MODE twice.
Changing the RDS mode
Notes
PS
PTY
RT
CT
Frequency
display mode
s
FREQ/RDS
PTY SEEK function
e
MODE PTY SEEK
f
START
Flashes
p
d PRESET
a
u
PTY HOLD
e
MODE PTY SEEK
f
START
Lights up
01EN.00_RX-SL100RDS.book Page 27 Thursday, November 27, 2003 12:42 PM