Zhone Technologies IMACS-200 - Manual (Page 133)

WAN Ports 5-3
WAN ports WAN port User Screens and Settings
Table 6-1 summarizes the actions you can perform from this screen, and Table 6-2 lists the
settings controlled on the screen along with their possible and default values.
Table 5-1. WAN Screen Actions
Table 5-2. WAN Screen Option Settings and Defaults
Notes: 1 is used to indicate a T1 field only, 2 indicates E1 only
STATE
In the standby state, the WAN port is electrically disconnected from the external network. Set
State setting to stdby (standby) when setting up your WAN links, then changes it to actv
(active) when starting normal operations.If the WAN is in loopback due to a command from
a remote device, the loopback will be dropped if you switch to stdby.
Action Function
Save Saves changes to settings.
Undo Returns all settings to the last saved state.
Refresh Updates certain time-related information fields that are not automatically
updated (i.e., performance and test data).
Xcon Displays the connections for the selected WAN port.
Perf Brings up the Performance Data Screen. See the Performance Data section of
this chapter.
Farstat Shows the far-end network register data.
Test Initiates and monitors testing of all WAN port ports. Refer to the Test section
of this chapter.
Main Returns to the System Main Screen. If changes are made to settings and not
saved, you will be prompted to save or abandon your changes.
Parameter User Options Notes Default
STATE stdby actv stdby
FORMAT d4 esf 1 esf
LINE CODE ami b8zs hdb3 b8zs or hdb3
FRAME crc d-frm 2
TS16 cas ccs nos 2
EVEN BIT norm inv 2
LINE LEN 110 220 330 440 550 660 0DB 7.5DB 15DB 22.5DB 1 110
LINE LB off on off
LOCAL LB off on off
LB GEN off llb plb nlb 1 off
LB DET w/to off on 1 w/to
EER THRHD 10e-4 through 10e-9 none 10e-4
COM/NMS RP none e-sa4 2 none