3Com TRGpro - Manual (Page 207)

Chapter 8 Page 199
Inserting and Removing Memory Cards
Inserting a CF memory card
1. Remove the CF card expansion slot door by pressing onto the
fingernail recess and sliding the door from the unit.
2. Begin the process of sliding the memory card into the unit. Grip
the card by its bottom edge, i.e., the edge opposite the connector
side.
3. The grooved sides of the card will only allow it to be inserted into
the slot one way. Place the card onto the rails of the slot and
attempt to slide it into the unit. If the card does not slide, flip the
card around, making sure the connector-side is still facing into the
slot.
4. Slide the memory card all the way into the slot until it fully mates
with the connector.
5. Replace the card expansion slot door by positioning the two tabs in
the slot groove and pressing onto the fingernail recess to push the
door locked.
Removing a CF Memory Card
1. Make sure the handheld computer is not currently copying
information from the CF memory card.
2. Remove the CF card expansion slot door by pressing onto the