Avaya S8300 - Manual (Page 2)

Jsl © 2002 Avaya Inc All Rights Reserved IP Enabling Siemens
Hicom with Avaya
MultiVantage Solutions
LPH 11-27-02 2
1. Introduction:
The configuration shown in figure 1 illustrates a PRI Trunk Connection between an Avaya
S8300 Media Server and an Avaya G700 Media Gateway (S8300/G700) running Avaya
MultiVantage Software placed as an adjunct to a Siemens Hicom 300.
The main Central Office connection for the solution is made through the Siemens Hicom 300.
Additional Central Office lines can be connected to the S8300/G700 in order to facilitate the
use of Avaya™ Extension to Cellular (EC500) and other Avaya MultiVantage Software
features.
This document assumes the reader has a basic knowledge of programming Multivantage and
Hicom platforms. Basic interoperability between S8300/G700 and Hicom 300 and how it was
accomplished is described within these application notes. It should be noted that the
interoperability of the S8300/G700 and Hicom 300 is established on basic network
fundamentals, and more advanced areas of networking and call routing such as QSIG, AAR
and ARS, while functional in this configuration, are not within the scope of this document. E-1
connectivity is possible but requires additional hardware and software upgrades. The
Siemens Hipath series is not covered in this document. The Hipath has very different user
interfaces and hardware architecture.
ISDN PRI
WAN/LAN
PSTN
Optiset E 6416D+
8405
4612 IP 4624 IP
CAJUN ® P330 S8300/G700
SIEMENS
HICOM 300
EC500
Optiset E
Figure 1. Avaya S8300/G700 and Siemens Hicom 300