Avaya S8300 - Manual (Page 3)

Jsl © 2002 Avaya Inc All Rights Reserved IP Enabling Siemens
Hicom with Avaya
MultiVantage Solutions
LPH 11-27-02 3
2. Equipment and Software Validated:
The configuration used to test performance of this solution was established in an Avaya Lab
setting within the guidelines and use parameters allowed in the user licenses acquired with the
equipment and software listed below.
Platform Version
Avaya MultiVantage Software 1.2
Avaya S8300 Media Server 213.0
Avaya G700 Media Gateway 3.12
Avaya™ 4612 IP Phones 46XXCommon.V36
Avaya™ 4624 IP Phones 46XXCommon.V36
Avaya MM710 T-1 Interface Firmware version 5
Siemens Hicom 300 30 EP Release 9006.5
DSC80 Processor Firmware version D961-D
TMDN64P T-1 Interface (Q2484-X) Firmware version D467-C
Optiset E Digital Advanced Plus Phones Model 69671
3. Requirements:
Avaya S8300 Media Server and an Avaya G700 Media Gateway:
Software:
1. Avaya MultiVantage Software Release 1.2 or newer
2. G700 Media Gateway Firmware Release 3.12 or newer
3. S8300 Media Server Software Release 213.0 or newer
Hardware:
1. MM710 DS1 Circuit pack. Installer needs to determine the number of trunks cards
that will be needed for traffic requirements. Consideration must be made for the
available slots and resources of the Hicom.
2. T-1 Interface cable. Connects the MM710 T-1 RJ45 interface port or the TN464 DS1
circuit pack to the Hicom. The actual cable needs to be custom built.
Siemens Hicom 300:
For this application to be successful, the intended switch must have:
1. Available slots for the T-1 boards.
2. Available purchased software ports for the T-1 spans.
3. T-1 boards must be compatible to software version.
4. If software or port capacities need to be upgraded, there are two options.
a. Siemens can be contacted and they will upgrade the system.
b. The software on DAT tape is purchased from Siemens or a vendor. The customer
loads the software.