3Com V7111 - Manual (Page 29)

5 To change the default gateway IP address, press 3 followed by the # key.
ƒ The current default gateway address of the gateway is played. Press # to change it.
ƒ Dial the new default gateway address; e.g. 192*168*0*1 and press # to finish.
ƒ Review the new default gateway address, and press 1 to save it.
6 Hang up the handset. Access the gateway's Embedded Web Server with the new IP
address you assigned (see
Accessing the Embedded Web Server ).
7 Reset the gateway. Click the Reset Device button on the main menu bar; the Reset
screen is displayed. Click the button Reset (with the Burn option selected).
Assigning an IP Address Using the CLI
First access the CLI using a standard Telnet application or using a serial communication
software (e.g., HyperTerminal
TM ) connected to the V7111 RS-232 port (see Access the CLI ).
Then assign the V7111 an IP address (see Assign an IP Address ).
Access the CLI
To access the CLI via the Embedded Telnet Server, follow these 3 steps:
1 Enable the Embedded Telnet Server:
Accessing the Embedded Web ƒ Access the V7111 Embedded Web Server (see
Server ).
ƒ Set the parameter ‘Embedded Telnet Server’ (under Advanced Configuration >
Network Settings
> Application Settings) to ‘Enable (Unsecured)’ or ‘Enable
Secured (SSL)’.
ƒ Click the Reset Device button on the main menu bar; the Reset screen is displayed.
ƒ Click the Reset button in the middle of the Reset screen with the Burn option
selected; the V7111 is shut down and re-activated. A message about the waiting
period is displayed. The screen is refreshed.
2 Use a standard Telnet application to connect to the V7111 Embedded Telnet Server.
Note that if the Telnet server is set to SSL mode, a special Telnet client is required on
your PC to connect to the Telnet interface over a secured connection.
3 Login using the username (‘Admin’) and password (‘Admin’).
To access the CLI via the RS-232 port, follow these 2 steps:
1 Connect the RS-232 port to your PC (For the V7111, see Table 5 . For the V7111 24-
PORT, see Table 7 ).
3Com VCX V7111 Analog Gateway Installation Guide 29