3Com Phaser Color Printer 860 - Manual (Page 58)

52 Phaser 860 Color Printer
Troubleshooting Phaser 860 Printers
Print quality problems
Light-colored or missing stripes on prints
■ Run a test print by choosing
Print Diagnostic Pages
on the printer’s front panel
(by selecting the
Support Menu
, then selecting
Improve Print Quality
).
■ If a light stripe appears in one color, clean the printhead by choosing
Eliminate
Light Stripes
on the front panel (by selecting the
Support Menu
, then selecting
Improve Print Quality
). Refer to the Phaser 860 Color Printer User Guide for
more information.
■ If a light stripe appears in all four colors, refer to the Phaser 860 Color Printer User
Guide for more information about how to:
■
Clean the Rapid Release Guide.
■
Clean the wiper blade on the maintenance drawer.
■
Inspect the printer's paper-exit area for debris and, if needed, clean this area.
■
Select
Eliminate Light Stripes
on the front panel to clean the print heads
and print a test page.
Ink streaks or oil on front, back, or edges of print
■
Choose
Remove Print Smears
on the front panel (by selecting the
Support Menu
,
then selecting
Improve Print Quality
). Refer to the Phaser 860 Color Printer User
Guide for more information. The cleaning process takes several minutes and uses
several blank sheets of paper.
■ Be sure to use paper supported by the printer. For a list of recommended media types,
refer to the Phaser 860 Color Printer User Guide or print the Paper Tips Page (from
the front panel).
■ If needed, clean the following parts of the printer, as described in the Phaser 860
Color Printer User Guide:
■
Clean the maintenance drawer wiper.
■
Clean the exit rollers if ink or debris is visible on those rollers.
■
Clean the paper-feed rollers if ink or debris is visible on those rollers.
Images are too light or too dark
■ Pull out the upper tray and check the position of the switch on the front-right side of
the tray. Push it forward for paper and backward for transparency. After setting the
switch correctly, push the tray back in.
■ Make sure that you have loaded the correct media (paper or transparencies). For a list
of recommended media types, refer to the Phaser 860 Color Printer User Guide or
print the Paper Tips Page (from the front panel).
■ Select another color correction in the printer driver, then print the job again. Refer to
page 3 for more information.