3Com 3800 - Manual (Page 145)

Boot Option Commands 10-3
Returning to Factory
Defaults
To return the Switch configuration to factory defaults, use the following
command:
unconfig switch
This command resets the entire configuration, with the exception of
user accounts and passwords that have been configured.
To reset all parameters, use the following command:
unconfig switch all
Boot Option
Commands Table 10-1 lists the commands associated with Switch 3800 boot
options.
Table 10-1 Boot Option Commands
Command Description
download image <ipaddress> <filename>
{primary | secondary} Allows you to download a new image from a TFTP
server. You must specify the IP address of the TFTP server
and the image filename. You can optionally specify if you
want the file downloaded to the primary or secondary
image. If you do not specify, the file is downloaded to the
primary image.
save config {primary | secondary} Allows you to save the current configuration of the Switch
to NVRAM. You can specify the primary or secondary
configuration area. If not specified, the configuration is
saved to the current configuration area in use.
use config {primary | secondary} Allows you to configure the Switch to use a particular
configuration on the next reboot. Options include the
primary configuration area or the secondary configuration
area.
use image {primary | secondary} Allows you to configure the Switch to use a particular
image on the next reboot. If not specified, the Switch will
use the primary image.
SW3800.BK Page 3 Tuesday, May 5, 1998 5:20 PM