3Com 3800 - Manual (Page 75)

Switch 3800 Commands 4-21
enable rip exportstatic Allows you to enable the advertisement of static
routes using RIP. The default setting is enabled.
disable rip exportstatic Allows you to disable the filtering of static routes.
config rip updatetime {<delay>} Allows you to change the periodic RIP update timer.
The default setting is 30 seconds.
config rip routetimeout {<delay>} Allows you to configure the route timeout. The default
setting is 180 seconds.
config rip garbagetime {<delay>} Allows you to configure the RIP garbage time. The
default setting is 120 seconds.
config rip txmode [none | v1only | v1comp
| v2only] {vlan <name> | all}
Allows you to change the RIP transmission mode for
one or more VLANs. Specify:
■
none — Do not transmit any packets on this
interface.
■
v1only — Transmit RIP version 1 format packets to
the broadcast address.
■
v1comp — Transmit version 2 format packets to the
broadcast address.
■
v2only — Transmit version 2 format packets to the
RIP multicast address.
If no VLAN is specified, the setting is applied to all
VLANs. The default setting is “v2only”.
config rip rxmode [none | v1only | v2only
| any] {vlan <name> | all}
Allows you to change the RIP receive mode for one or
more VLANs. Specify:
■
none — Drop all received RIP packets.
■
v1only — Accept only RIP version 1 format packets.
■
v2only — Accept only RIP version 2 format packets.
■
any — Accept both version 1 and version 2 packets.
If no VLAN is specified, the setting is applied to all
VLANs. The default setting is “any”.
unconfig rip {vlan <name> | all} Allows you to reset all RIP parameters to the default
VLAN. Does not change the enable/disable state of the
RIP settings.
Table 4-17 RIP Commands (continued)
Command Description
SW3800.BK Page 21 Tuesday, May 5, 1998 5:20 PM