Fein KBM32Q - Manual (Page 15)

KBM 32 Q
15
EN
➤ Switch on the main (magnet) switch (5)
for the magnet to clamp and hold the core
drill.
Starting and stopping the motor:
Starting:
➤ Switch on the motor switch (2).
Stopping:
➤ Switch off the motor switch (2).
Putting out of operation:
➤ Switch the magnet off by pressing the
main switch (5).
Instructions:
– The magnetic foot (6) is monitored by a cur-
rent sensor. If the magnetic foot is defective
the motor will not start.
– The motor automatically switches off in the
case of overload. It can be restarted with
motor switch (2).
– If the current supply is interrupted while the
motor is running, a protection circuit prevents the
motor from restarting automatically. The motor
has to be restarted with motor switch (2).
Working instructions for core drilling.
➤ Punch-mark the drilling place marked.
➤ Position the drill bit with the centering
pin (12d) on the punch-mark.
➤ Carefully start boring until a circular cut
is formed.
Do not stop the drill motor during the
drilling procedure.
Only remove the core bit from of the drill-
ing hole while the motor is running.
➤ If the core bit should remain stuck in the
material, stop the drill motor and carefully
turn the core bit out anti-clockwise.
Remove the chippings and the bored core
after each drilling process.
Do not touch the chippings with your bare
hand. Always use a chip hook.
Do not damage the cutters when changing
the bit.
➤ When core drilling layered material,
remove the core and the chippings after
drilling each layer.
Repair and customer service.
Regular cleaning.
Carry out the following steps once a week, or
more often if used frequently:
➤ Clean the cooling air vents.
Use non-metallic tools to clean the air vents.
➤ Blow out the interior of the power tool
at regular intervals from outside through
the air vents with dry, compressed air.
If required, you can change the following parts
yourself:
– Application tools
– Coolant container (12h)
– Coolant tube (12j)
For repairs, we recommend our FEIN customer
service centre, the FEIN authorised service cen-
tres and FEIN agencies.
When carrying out your own repairs by quali-
fied electricians we supply the repair documen-
tation upon request.
Repairs may only be carried out by quali-
fied electricians in conformity with the
valid regulations.
Please always hand this Instruction Manual
to the those carrying out the repair.
If the supply cord of this power tool is
damaged it must be replaced by a specially
prepared cord available through the FEIN cus-
tomer service centre.
Accessories.
Only use accessories recommended by FEIN.
Warranty and liability.
The warranty for the product is valid in accord-
ance with the legal regulations in the country
where it is marketed.
In addition, FEIN also provides a guarantee in
accordance with the FEIN manufacturer’s guar-
antee. For further details on this, please contact
your specialist dealer, your national FEIN repre-
sentative, or the FEIN customer service centre.
3 41 01 011 06 3.book Seite 15 Mittwoch, 20. Juni 2007 7:58 07