ROWENTA ESPRESSO ES060 - Manual (Page 4)

6
EN
replaced by the manufacturer, a service
centre, or a person with an equivalent
qualification, to avoid any danger.
This product has been designed for
domestic use only. Any commercial use,
inappropriate use or failure to comply with
the instructions, the manufacturer accepts
no responsibility and the guarantee will not
apply.
• This appliance can only be repaired with
special tools. In the event of damage to the
supply cord or for any other problem, you
should contact an approved service agent.
• This appliance has been designed for
domestic use only. It is not designed to be
used in the following cases, which are not
covered by the guarantee:
- In staff kitchen areas in stores, offices
and other working environments
- In farms houses
- By customers in hotels, motels and other
residential environments
- Bed and breakfast type environments.
BEFORE FIRST USE
- We recommend that you familiarise yourself
with all of the parts of the appliance before
using it. Insert the filter into the filter holder,
fit the filter holder into the rings designed to
hold it and remove and refit the boiler cap.
- Check the different positions of the function
selector.
- To ensure that any residues from the
manufacturing process are removed, we
recommend operating the appliance (as
described in the "Preparing an espresso"
section) once or twice using just water and no
coffee.
- Wash all removable parts in warm, soapy
water, then rinse thoroughly and dry them.
- Read all instructions, warnings and
guidelines carefully before using the
appliance.
WARNING – PRESSURE
Do not remove the boiler cap or the filter
holder while the appliance is operating and
while there is still pressure in the boiler.
Do not move or remove the filter holder when
the appliance is operating and pressurised.
Follow the instructions to check if the
appliance is still pressurised.
Apply these safety instructions when the
appliance is operating and for 10 to 15 minutes
after it has been switched off.
- Turn the function selector to the position
(steam). If steam comes out of the nozzle, the
boiler is still pressurised. Move the function
selector to the "0" position (Off). Take a jug of
cold water and insert the steam nozzle into it.
Turn the function selector to the position
(steam). Let all of the steam out then stop the
steam function by loving the function selector
back to the "0" position (Off).
- You may now remove the boiler cap and the
filter holder.
- Warning: If all of the pressure has not been
released, you cannot unscrew the water tank
lid.
ESPRESSO
Espresso is much richer and tastier coffee than
ordinary filter coffee. When this appliance is
used correctly, you will obtain a creamy, dark
and tasty espresso. Simply follow the
instructions and use fresh, well roasted and
pre-ground espresso coffee.
Espresso or cappuccino coffees are not
prepared in the same way as ordinary filter
coffees. One of the main differences lies in the
fact that the water is boiled before being forced
through the ground coffee. This means that the
espresso machine operates under pressure
and requires particular attention.
WARNING – HOT
Do not unscrew the boiler cap during the
preparation. Let the pressure escape. Refer to
the "WARNING – PRESSURE" section.
Preparing an espresso
1. Place the appliance close to a wall socket
and unwind the length of power cord
necessary to plug in the appliance.
2. Place the filter inside the filter holder and
rotate it so that it is firmly locked in place
(figure 5) .
3. Fill with ground espresso coffee. The filter
has indicator levels for 2 or 4 cups. Pack
down the coffee lightly and remove any
residues from the edge of the filter holder, so
that it may be fitted correctly into the
percolator head
(figure 6)
.
RO_ESPRESSO_ES060_8080011056 07/02/12 17:36 Page6