TIMBERK TMS 08.CH - Manual (Page 13)

ENGLISH
2. Switching on
Press ON/OFF button, symbols will be shown on the remote controller's display and POWER
indicator will ash on the control unit.
3. Setting a heating power mode
3.1. For TCH A2 infrared heater
3.1.1. Press HEAT button
3.1.2. To con rm the selection, press HEAT button again in 5 seconds after press HEAT
button, then a sound signal will be made, heating will be switched on, and heating
indicators will ash on the control unit.
3.2. For TCH A1N infrared heater
3.2.1. Press HEAT button, at that « » symbol will ash on the remote controller and start
blinking.
3.2.2. Press « » or « » button to select the high power mode ( « »symbol) or low
power mode ( « »symbol).
3.2.3. To con rm the selection, press HEAT button again in 5 seconds after press HEAT
button, then a sound signal will be made, heating will be switched on, and heating
indicators will ash on the control unit.
4. Setting timer functions to switch o the heater
4.1. When the heater operates in the heating mode, press « » button, then [00] value will
be shown on the display and start blinking.
4.2. Press « » or « » button to set the heater switch o time, with 1 hour increment, 0 to
13 hours. The display will show the countdown of time, remaining till the heater is switched
o .
13 www.timberk.com remote control block