TP-Link TL-WR940N - Manual (Page 45)

300Mbps Wireless N Router TL-WR940N/TL-WR941ND
-37-
¾ SSID(to be bridged) - The SSID of the AP your router is going to connect to as a client.
You can also use the search function to select the SSID to join.
¾ BSSID(to be bridged) - The BSSID of the AP your router is going to connect to as a
client. You can also use the search function to select the BSSID to join.
¾ Survey - Click this button, you can search the AP which runs in the current channel.
¾ WDS Mode - This field determines which WDS Mode will be used. It is not necessary to
change the WDS Mode unless you notice network communication problems with root
AP. If you select Auto, then router will choose the appropriate WDS Mode automatically.
¾ Key type - This option should be chosen according to the AP's security configuration.It
is recommended that the security type is the same as your AP's security type
¾ WEP Index - This option should be chosen if the key type is WEP(ASCII) or
WEP(HEX).It indicates the index of the WEP key.
¾ Auth Type - This option should be chosen if the key type is WEP(ASCII) or
WEP(HEX).It indicates the authorization type of the Root AP.
¾ Password - If the AP your router is going to connect needs password, you need to fill
the password in this blank.
4.6.2 Wireless Security
Choose menu “Wireless→Wireless Security”, you can configure the security settings of your
wireless network.
There are five wireless security modes supported by the router: WEP (Wired Equivalent Privacy),
WPA (Wi-Fi Protected Access), WPA2 (Wi-Fi Protected Access 2), WPA2-PSK (Pre-Shared Key),
WPA-PSK (Pre-Shared Key).