MITSUBISHI ELECTRIC LDT462V - Manual (Page 55)

English-51
English
OSD screen functions (continued)
ADVANCED OPTION

INPUT RESOLUTION
* For the D-SUB inputs only.
If the monitor fails to recognize the input signal resolution
correctly, you can select a proper resolution manually.
Only when a signal having a resolution close to any of the
following values from three groups, the values in the most
appropriate group are selectable.
Group 1: AUTO, 1024 x 768, 1280 x 768, 1360 x 768
, 1366 x 768
Group 2: AUTO, 1400 x 1050, 1680 x 1050
Group 3: AUTO, 1600 x 1200, 1920 x 1200

BLACK LEVEL EXPANSION
* For the HDMI (Automatically selected depending on the
input signal.), DVI-D, OPTION (SDI), YPbPr, S-VIDEO,
and VIDEO inputs only.
Select the level of black expansion from OFF, MIDDLE, and
HIGH.

INPUT CHANGE
You can select the time for input switching from QUICK and
NORMAL.
NOTE: When you select QUICK, slight noise may appear.

INPUT DETECT
When two ore more computers or video devices are
connected, this function detects and automatically selects
an input video source.
AUTO SELECT
* For the DVI-D, D-SUB, and OPTION inputs only.
The DVI-D or D-SUB input port, either of which is carrying
a video signal, is automatically selected.
When no signal is present at either of them for 5 seconds,
the monitor enters the sleep mode.
When an extension module such as an SDI BOX is in the
option slot, DVI-D isn’t detected and OPTION is selected.
NOTE: Video signals carried by the HDMI, YPbPr,
S-VIDEO, VIDEO, and DisplayPort input ports
aren’t detected.
When an extension module is mounted, the
monitor doesn’t enter the sleep mode.
VIDEO DETECT
When the function detects a video signal carried by any
of the HDMI, YPbPr, S-VIDEO, and VIDEO input port, it
automatically selects the input port.
When the video signal being displayed is lost, any of the
D-SUB input ports previously selected was automatically
selected again.
NOTE: When an extension module is mounted, the
monitor doesn’t enter the sleep mode.
OFF
Video inputs aren’t selected automatically.

SCAN MODE
* For the HDMI, YPbPr, S-VIDEO, and VIDEO inputs only.
You can select the image display area.
OVERSCAN:
About 95% of the input image is displayed.
UNDERSCAN: Almost 100% of the input image is
displayed.

SCAN CONVERSION
* For the HDMI, YPbPr, S-VIDEO, and VIDEO inputs only.
You can select the IP conversion mode.
PROGRESSIVE: Interlace signals are converted into
progressive signals. Select this setting for
normal cases.
INTERLACE: Interlace signals are displayed without
being converted. Though this setting is
suitable for motion images, still images
aren’t displayed properly.

FILM MODE
You can select the fi lm mode function.
AUTO: Images of 24 frames per second are detected,
subjected to interpolation, and then displayed.
OFF: The input video signals are displayed without being
subjected to any processing.
NOTE: When FILM MODE is AUTO, set SCAN CONVERSION
to PROGRESSIVE. See page 51.