HONDA 2011 Accord Coupe - Manual (Page 373)

To change the passenger’s side
bulb, start the engine, turn the
steering wheel all the way to the
left, and turn off the engine. To
change the driver’s side bulb, turn
the steering wheel to the right.
Install the new bulb, and turn it
one-quarter turn clockwise to lock
it in place.
Push the electrical connector onto
the bulb.
Turn on the headlights to test the
new bulb.
Reinstall the engine coolant
reserve tank.
Remove the electrical connector
from the bulb by pushing on the
tab to unlock it, then slide the
connector off the bulb.
Remove the bulb by turning it
approximately one-quarter turn
counterclockwise.
Pull the inner fender cover away
from the fender and bumper.
Use a flat-tip screwdriver to
remove the two holding clips from
the inner fender.
Reinstall the air intake cover and
duct securely. Reinstall the
fastener and secure it by pushing
on the head until it locks.
6.
5.
3.
4.
5.
1.
2.
7.
4.
CONTINUED
Passenger’s side
Driver’s side on V6 models
Low Beam Headlight
Lights
Ma
int
e
na
nce
367
HOLDING CLIPS BULB
TAB
10/07/12 17:05:27 31TE0630_372