HONDA 2011 Accord Coupe - Manual (Page 403)

Place the flat tire face down in the
spare tire well.
Remove the spacer cone from the
wing bolt, turn it over, and put it
back on the bolt.
To remove the spacer cone, squeeze
the tabs on the wing bolt to
disengage it from the center of the
spacer cone, then pull the bolt
downward.
To install the wing bolt to the spacer
cone, reverse this procedure.
Secure the flat tire by screwing
the wing bolt back into its hole.
Store the jack and tools in the tool
kit case. Place the tool kit case in
the flat tire.
Your vehicle’s original tire has a
tire pressure monitoring system
sensor. To replace a tire, refer to
(see
page ).
Lower the trunk floor, then close
the trunk lid.
Store the center cap in the trunk.
Make sure it does not get
scratched or damaged.
16.
17.
19.
18.
20.
21.
22.
328
Changing a Flat Tire
Changing a Tire with TPMS
T
a
k
ing
Ca
re
of
th
e
U
ne
x
p
e
c
te
d
397
WING BOLT
SPACER CONE
SPACER CONE
TAB
Loose items can fly around the
interior in a crash and could
seriously injure the occupants.
Store the wheel, jack, and tools
securely before driving.
10/07/12 17:10:41 31TE0630_402