HONDA 2012 Pilot Navigation - Manual (Page 22)

Navigation System 21
PILOT KA 31SZA830
Getting Started
Map Screen Description
Zoom In/Out
Rotate the
Interface Dial knob to
change the map scale. Zooming in
increases the detail, while zooming out
gives you a wide area view. After
changing the scale, give the system a
few moments to update the display.
Map Scrolling
To view other map areas, move the
Interface Dial left, right, up, or down.
The map will shift in that direction. To
return the map to your current location,
press either the
MAP/GUIDE,
CANCEL, or BACK button on the
steering wheel.
Displaying Current Location
You can see the current address,
latitude, longitude, and elevation at any
time by doing one of the following:
• Use the voice control system and say
“Display the current location.”
• Push in on the Interface Dial while
displaying the map of the current
location, and select
Map
Information. Rotate the Interface
Dial knob to select Current
Location.
The
Current location screen will
appear on the display.
NOTE:
The elevation will not appear when the
system is temporarily lacking proper
GPS information. The system elevation
may not agree with elevations shown on
roadside elevation signs, and may
fluctuate plus or minus 100 feet or more.
You can save the current location in
your Address Book by doing one of the
following (if an Address Book PIN has
been set, you need to enter your PIN.):
• Use the voice control system and say
“Save.”
• Select Save by rotating the
Interface Dial knob and push in on
the
Interface Dial.
Say “Register the current location” on
the
map screen, and you can register the
current location without displaying the
Current location screen.
Select Return to return to the previous
screen.
00 PILOT_KA-31SZA830.book 21 ページ ２０１１年７月２４日 日曜日 午後５時１４分