Candy VI 64 CPN - Manual (Page 16)

- 37
è The programmed time can be modified at any moment by pressing the timer selection
button, the timer control LED must be on.
When the time has run, the cooking zone goes off automatically and an audible beep
sounds for 1 minute. Press the timer button to stop it.
è The programmed time can be reset to using the button or pressing the
and buttons at the same time, the cooking zone is then no longer linked to the timer
but stays operational. So you will have to stop the zone independently.
è The timer can be used alone as a reminder, it will ring at the end of the programmed
time.
• LOCKING BUTTON OPERATION
The locking function holds the current settings, or prevents anyone from starting the
hob. It is also used for cleaning the control strip as the controls can be locked
without the hob being on.
. Start the required cooking zones.
. Select a heat level for each of them.
. Press the button to set the data; in this way
no other button works, except the On/Off button.
The locking indicator lamp comes on.
è To release the locking function, just press the button; the indicator lamp goes
off, all the controls work again.
If when the controls are locked, the timer is on, the time will be counted automatically and the zone
switched off at the end of the programmed time. .
If the locking control is on when the hob is finally shut down, the locking control
stays operational and prevents any action when the hob is restarted, press the
button to release the locking function.
locking indicator lamp