Candy VI 64 CPN - Manual (Page 19)

40 -
The induction hob gives shorings
out
The induction hob gives a light
whistling out.
The cooking zones do not
simmer or only fry gently.
The cooking is too slow.
Small scratches or abrasions on
the hob’s glass surface.
Metal marks.
Dark stains.
Light surfaces on the hob.
• Normal. The cooking fan of the electronic
components is on.
• Normal. According to the working frequency of
the inductors, a light whistling can occur when using
several cooking zones on maximum power.
• Only use flat-bottomed pans. With high light zone,
if light is visible between the pan and the hob, the
zone is not transmitting heat correctly.
• The pan bottom should fully cover the diameter
of the selected zone.
• Unsuitable pans are being used. Only use flat-
bottomed utensils, that are heavy and have a diameter
at least the same as the cooking zone.
• Incorrect cleaning or rough-bottomed pans are used;
particles like grains of sand or salt get between the
hob and the bottom of the pan. Refer to the
«CLEANING» section; make sure that pan bottoms
are clean before use and only use smooth bottomed
pans. Scratches can be lessened only if the cleaning is
done correctly.
• Do not slide aluminium pans on the hob. Refer to
the cleaning recommendations.
• You use the correct materials, but the stains
persist. Use a razor blade and follow the
“CLEANING” section.
• Use a razor blade and follow the «CLEANING»
section.
• Marks from an aluminium or copper pan, but also
mineral, water or food deposits; they can be removed
using the cream cleaner.
PROBLEMS AND SOLUTIONS