Candy VI 64 CPN - Manual (Page 5)

26 -
The unit or support for the hob, as well as the walls of any adjacent units, must be made
of high temperature resisting material. In addition, the laminate covering the unit or
support should be laid using heat-resistant adhesive to prevent it coming away.
Installation:
• A seal is supplied with the hob. To install it,
. turn over the hob, glass side down, taking care to protect the glass.
. place the seal all round the hob.
. make sure it is placed correctly to prevent any ingress in the support unit.
• It it important to fit the hob on a level supporting surface.
• Deformations caused by incorrect fitting can alter the specifications of the worktop and
the performance of the hob.
• Leave a gap of at least 5 cm between the appliance and any neighbouring vertical
surfaces.
• It is absolutely essential that the recess conforms with the dimensions indicated.
• The height of the flush-mounted part of the hob is 5 cm.
• If there is an intermediate division :
. the clearance between the bottom of the casing and in intermediate floor or part of a
furniture unit must greater than 2,5 cm so as to allow air circulate. The minimum
distance should be 7,5 cm.
. furthermore, you should ensure that there is at the rear a ventilation (8 cm).
• You can not build the hob in above an oven with no fan, a dishwasher, fridge, freezer or
washing machine.
• The body of the hob is fitted which 4 location holes to take the fixing clamps intended
to fix the hob in the unit. Place the 4 fixing clamps, before building-in the hob, in such
a way that the hob is placed perfectly in the support unit.
INSTALLATION - FITTING
Hob casing
Hob with glass side down
Hob glass
Seal