Accusys ExaSAN SW-08 - Manual (Page 30)

2.2.1.3 Add More Computers into the SAN
You can add more computers into the SAN by clicking the “Add (+)” button in the “Computers” pane.
2.2.2 Adding the ExaSAN RAID System into the SAN
Now we will check accessible LUNs and then create an Xsan volume.
2.2.2.1 Labeling LUNs
Before we label the two LUNs, first verify that they are listed in the “Parallel SCSI” pane under “Hardware.” Launch
Xsan Admin and then click the “LUNs” tab to check if the two LUNs are also there. Follow the screenshots below to
label the smaller of the two LUNs as “Meta-LUN.” Label the larger of the two LUNs as “Data-LUN.”
At first, see that there is no name assigned to either LUN under the “LUN Label” column header. The sizes of these
two LINs are at 372.58GB and 1.45 TB respectively.
Right-click on the 372.58GB LUN (smaller of the two), the options menu displays, select “Change LUN Label.”
Quick Start Guide
P28