Accusys ACS-7630 - Manual (Page 16)

Accusys 7630
16
Setting configurations
The RAID (level 0 or 5) and master / slave configurations are set manually by placing jumper
heads on the nine jumper pins on the rear of the controller box.
Master/Slave configuration
jumper pins
RAID level configuration jumper
pins
RAID 0 configuration
1. Make sure the power is turned off.
2. Make sure the six RAID configuration
jumper pins are clear of any jumper
caps.
RAID 5 configuration
1. Make sure the power is turned off.
2. Place two jumper caps over the central
and left pairs of RAID configuration
jumper pins.