Accusys ACS-7630 - Manual (Page 8)

Accusys 7630
8
Key features
The ACS-7630 supports the following features:
Automatic on-line rebuilding
Drives are hot swappable
Supports RAID level 0 and 5
Can be configured as master or slave IDE drive
Host transparent and OS independent
Fan cooler (Ball bearing type)
Supports 3 IDE hard drives
Key locking to prevent unauthorized access to the disk drives
Requires no software drive or add-in card
Audible alarm on drive failure
Hard drive hot swapping
Hot Swapping allows for the removal and installation of disk drives without the need to power
down the system while ACS-7630 is configured as a RAID 5 array.
Automatic drive rebuilding
If a member drive in a RAID 5 array is replaced on-line, the controller will automatically start to
rebuild data to the new drive.
Making sure you have everything
What's in the box
Some vendors may ship certain components as standard, while other vendors treat the same
component as optional. In its most basic configuration, your package should include the
following:
ACS-7630 Controller Box
ACS-7630 Controller User’s Manual
Three disk drive carriers with key locks
Disk drive mounting screws
Two keys for drive carriers (identical)
What else you need
In order to setup a working system the following user-supplied items are required:
System with IDE/ATA Interface
Case with two half-height 5 ¼” drive bays with front bezel access
One IDE channel cable connector
One free power supply connector
One 3-pin RS232 cable connector (data connection for GUI interface, if required)