Accusys ACS-7630 - Manual (Page 20)

Accusys 7630
20
Fixed connector drive carrier
The ACS-7630 should be fitted with three hard disk drives (HDDs). Load each drive into a
drive carrier as follows:
1. Unlock the drive carrier and slide it out of
the controller box.
2. Place the disk drive in the drive carrier, so
that the power and IDE connectors are
lined up with the connectors inside the
carrier.
3. Connect the power connector to the disk
drive first, then carefully push the disk
drive so that the drive’s IDE connector is
seated securely into the IDE connectors in
the disk carrier.
4. Push the power connector into the drive
connected to ensure it is firmly secured.
5. Secure the disk drive by screwing it to the
drive carrier case.
6. Slide the loaded disk drive carrier into the
ACS-7630 Controller Box and lock it.
The disk carrier connector at the back of each controller box disk carrier slot
can be damaged if the disk carrier is not properly aligned when inserted.
Insert the disk carrier gently to avoid damage.