Acroprint TQ600M (software version 4.x and above) - Manual (Page 3)

Page 3 of 5
5) Connect the TQ600BC/M to the power supply then plug the power supply
into a power outlet.
Program bell schedules (see pg. 5).
6) Verify that the External Signal Device is working properly. If it doesn’t
activate check to see if the TQ600BC/M is set to the correct time. If the
time is correct check to see that the bell schedule is correct and verify
the schedule for AM or PM settings. If the external device still does not
activate check all connections and verify that the power outlet is working.
Internal Schematic and Hookup for 01-0230-000 Relay
1 Power Supply: Provide Overload
Protection and Disconnect Means
as Required.
RA89A (SPST)
1
Wht Blk
2 1 3 4
T T
120vAC
Signal Device 120vAC
NO
COM
TQ600BC/M
(see pg. 4 for more detail)