Acroprint TQ600M (software version 4.x and above) - Manual (Page 5)

How to Set a Bell Schedule on the TQ600BC/M
Note:
Page 5 of 5
The Internal Bell of the TQ600BC/M is disabled when the External Bell is Activated.
Menu> Options> Power Mng> Ext.Bell: Set to “Y”
1) Activate the External Bell option on the TQ600BC/M:
Scheduled Bell
No. 1 N
No. 1 N
No. 1 N
You can set up to 50 bell events.
The following screen will be displayed:
a) Select the Bell# you wish to set and press “Ok”.
b) Press “OK”. The following screen is displayed:
c) Enter the hour of the first bell (in military time).
It is recommended that you write down your complete bell schedule
before setting the schedule on the terminal.
The following screen is displayed:
Scheduled Bell
Set Sch. Fun?
ESC OK
Scheduled Bell
No. 1 23:59
No. 1 N
No. 1 N
Press either arrow key to set the min of the first bell:
Press “OK” to set the first bell.
d) Select the next bell# and enter the schedule. Repeat until all bells schedules
have been entered.
2) Set the Bell Delay (the duration of the External Bell):
Menu> Options> Power Mng> Bell Delay (0 - 999 sec)
3) Set the Bell Schedule:
Menu> Options> Power Mng> Scheduled Bell
Note: it make take up to 7 seconds for the Bell Schedule to be displayed.
e) Press “ESC” then press “OK” to save all bell schedules.
Press “ESC” until the terminal menu is exited.
TQ600BC-M Ext. Bell_031412