Activeforever Image EC Mid Wheel Drive Reclining Power Wheelchair - Manual (Page 11)

10
5. OPERATION
JOYSTICK AND CONTROLLER
Your Image EC is operated by a joystick and controller. The Image EC is currently available
with the PG VR2 Controller.
VR2 Series CONTROL FUNCTIONS
1. ON/OFF Button 2. Battery Gauge 3. Joystick
4. Maximum Speed / Profile Indicator
5. Speed / Profile Decrease Button 6. Horn Button
7. Speed / Profile Increase Button
■ HOW TO OPERATE YOUR Image EC
◆ ON/OFF Button
The ON/OFF button applies power to the control system
electronics, which in turn supply power to the power chair’s
motor. Do not use the ON/OFF button to stop the power chair
unless there is an emergency.
Attention:
If you use the ON/OFF button to stop the power chair, it may shorten the life of the
drive components
◆ Battery Gauge
The battery gauge shows you that the power chair is switched on. It also indicates the operating status
of the power chair.
◆ Joystick
The primary function of the joystick controls the speed and direction of the power chair. The further you
push the joystick from the center position the faster the power chair will more. When you release the
joystick the brakes are automatically applied.
◆
Maximum Speed / Profile Indicator
This gauge shows the maximum speed setting of the power chair.
There are five speed settings. Step 1 is the lowest speed and Step 5 is the highest speed.
4
2
6
3
7
5
1