Activeforever Image EC Mid Wheel Drive Reclining Power Wheelchair - Manual (Page 16)

15
5. OPERATION
▇ To change the seat height
1. Remove seat (See “To remove the Seat”)
2. Remove the shroud.
3. Disengage and remove the seat height adjustment bolt from the seat post.
4. Remove the height adjustment bolt from each of the three posts.
5. Raise or lower each post to the desired position.
6. Reinstall the seat height adjustment bolt through the seat post.
7. Reinstall the shroud.
8. Reinstall the seat.
HOW TO ADJUST THE FOOTREST
▇ To adjust the footrest angle
You can adjust the angle of the footrest with a hex wrench (M6).
◆ Turn the setscrew clockwise to raise the front of the footrest.
◆ Turn the setscrew clockwise to lower the front of the footrest.
▇ To adjust the footrest height
◆ Remove the quick release pin.
◆ Adjust footboard to one(1) of three (3) mounting positions.
◆ Install the quick release pin. Make sure the detent ball is engaged with the outer edge of the tube.
HOW TO SET THE FREEWHEEL MODE
For your convenience, the Image EC Plus is equipped with a freewheel level. This level allows you to
disengage the drive motors and maneuver the chair manually.
▇ To engage the drive and take power chair out of freewheel
◆ Pull the freewheel lever to the “DRIVE” position (left and right).
◆ Activation of the joystick automatically releases the brake so the powered Image EC can be
driven.
▇ To disengage the drive and place power chair in freewheel
◆ Push the freewheel lever to “NEUTRAL” position (left and right).
Setscrew
Luck Nut Bolt