Activeforever Slendertone ReVive Back Pain Relief Belt - Manual (Page 10)

If you should encounter any problems using the BMR ReVive unit, review
this troubleshooting guide for a possible solution to the problem. If the
problem persists, please do not attempt to repair the BMR ReVive unit
yourself, contact our Customer Careline at:
1-800-377-8033
BMR ReVive Unit Maintenance
Never let your BMR ReVive control unit get wet, but you may clean the outside
using a soft cloth, lightly dampened in soapy water. The belt is washable, but
you must first remove the BMR ReVive control unit and GelPads. You must
always follow the instructions on the label when washing the belt.
Never machine wash your BMR ReVive belt. Hand wash the belt in
lukewarm water and NEVER wring the belt to remove water. This pro-
tects the internal wiring of the belt from damage. All fasteners should
be closed prior to washing.
Do not use any bleach when washing your BMR ReVive belt.
Do not dry clean the BMR ReVive belt.
Do not tumble dry your BMR ReVive belt. You should always dry the belt
on a flat surface. Never dry the belt over anything hot (e.g. a radiator)
as it contains plastic parts. You should ensure the belt is completely
dry before use.
The BMR ReVive belt must not be ironed.
Care for the GelPads
• The GelPads are for single person use only.
• You should ensure your skin is clean and free of oils, creams and other lotions
before use.
• The durability and effectiveness of the GelPads depends entirely on the proper
use, storage and care on the part of the user, certain skin types and the type,
duration, number of sessions, intensity used and site of stimulation.
• Ensure your hands are clean before handling GelPads. You should avoid
touching the skin-side of the pads with your fingers as much as possible when
applying or removing the belt, as this can transfer oils and skin particles to the
GelPads’ surface.
• After use, replace the liners on the black side of the GelPads and store your
unit in a cool, dry place until the next use.
• GelPads will need to be replaced periodically as the surface picks up skin
debris and becomes dry over time.
10
T R O U B L E S H O O T I N G T R O U B L E S H O O T I N G G U I D E G U I D E & &
U N I T U N I T M A I N T E N A N C E M A I N T E N A N C E
Solution
Reposition the battery as described
on page 7. If necessary, replace the
battery.
Disconnect the unit from the plug
and then reattach it.
Replace the battery. Use only a
high-quality, alkaline battery with
your unit.
Press studs firmly into connectors.
Fasten the hook and loop straps
more tightly.
Re-insert the unit.
Re-apply GelPads.
Make sure the liners on both sides
of the GelPads have been removed.
Contact your local retailer for new
GelPads.
Reposition the belt.
Remove any lotions or oils by
washing.
Problem
The display doesn’t come on &
there is no signal from the unit
The unit is turned on, but there
is no output
The battery symbol is flashing,
and
there is ineffective stimulation
The stimulation is very weak
even when the intensity is high
The pad contact symbol
appears on the display
Unpleasant feeling beneath the
GelPads