Activeforever Slendertone ReVive Back Pain Relief Belt - Manual (Page 5)

D E S C R I P T I O N D E S C R I P T I O N O F O F T H E T H E B M R B M R R E V I V E R E V I V E C O N T R O L C O N T R O L U N I T U N I T
1. On/Off (Pause) Button
Switches the control unit on and off and to pause a treatment session. Press this button for 2 seconds to
switch the unit on or off. To pause a treatment session, simply press the On/Off button briefly. The unit will
beep and the pause symbol ( ) will appear on the display to indicate that the program has been paused. To
restart a paused program, just press the On/Off button briefly again.
2. Program Button
Enables you to select your required treatment program.
3. Intensity Controls
Each intensity control corresponds to a channel on the same side of the unit. Pressing the upper button ( )
during treatment increases the intensity level from that channel. Pressing the lower button (
) decreases the
intensity level.
4. Keylock Button
Once you have reached a comfortable intensity level the Keylock may be used to prevent any accidental
changes to the intensity levels. To do this, press the Keylock button. To stop the Keylock function simply
press this button again. This function is also used to lock the Burst Mode function.
5. Burst Mode Button
Burst Mode is available for all programs and changes the sensation of the treatment. When the button is
pressed Burst Mode is activated. To stop Burst Mode press the button a second time.
Note:
The Keylock and Program buttons are used simultaneously to reset the Total Treatment Time. To do this,
press the Keylock button first and then the Program button. A tone will sound and the display will reset to zero.
This function is available only at the start of a treatment session. See page 8 for Operating Instructions.
5
1
2
3
5
3
4