Emergency factory default – Acumen AiP-I04Z User Manual
Page 30
29
Please click on Manage Cameras button. A list of camera names shows on the screen.
Please select one of the cameras and click on Edit button.
“Add/Edit AiP camera” dialog box gets prompted for editing an AiP camera or a DVR.
In “Add/Edit AiP camera” dialog box, please enter the following information:
1. Name: Name of the AiP camera
or DVR’s camera
2. Category: Please select AI.
3. Type: Select device type, AI D1/ AI HD/AI DVR.
4. IP Address: Please type IP address, for examp
where 86 is the port number.
5. Provide username and password information. For AiP camera, the default
username and password ar
e “admin” and “pass”. For DVR, the default
username and password are “admin” and “1111”.
Once above information is entered, please click “Save” button. You are able to see live
video of the AiP camera
or DVR’s camera.
Emergency Factory Default
To restore the server to factory default settings, please:
1.
Hold Load Default Button or short Reset Cable for 10 seconds, then release the
button or Reset Cable.
2. After about 40 seconds, the network LED light is off, and then it becomes lit
again.
3. This camera has completed the factory default setting, and it reboots.
4. Use IPScan scanning for the IP address of the IP device.
5. Launch Internet browser for the IP address of the IP device.
6.
Type default username “admin” and password “pass” for enter web interface of
the IP device.