Acura Embedded AcuBrite 15″-Nav - Manual (Page 14)

AcuBrite 15-Nav Manual
<Add> / <Remove>
Please check the touch panel devices (including its controller) are equipped well, Then click [Add] button to add
all of those RS-232 and PS/2 devices to the Panel List dialogue box
.
There is one devices found. Press [Yes] to continue.
The controller is displayed on the Panel List box. Users can get the information of interface, type, firmware
version and baud rate for each controller. Select one device after added more than one device at the panel list
window. The one selected will activate the panel, and remember to do the calibration before starting to use
touch panel.
But, for hot-swapping USB touch controller, it will be added automatically as soon as it was plugged into the
computer. Then users can see the new device on the application program window. And, the program will
remove the USB touch controller automatically as soon as it was unplugged. (USB device is not supported for
Windows95)
There are three buttons, [4pts Cal] [Draw Test] [Advanced], at the lower section of the General property
page.
Page 13