Acura Embedded AcuBrite 15″-Nav - Manual (Page 27)

AcuBrite 15-Nav Manual
VR BRIGHTNESS Key
If you want to enable the VR Brightness function, you need to press “MENU” KEY and then choose VR function.
When you rotate the VR knob, the VR BRIGHTNESS status bar will appear as below image (dimming range
from 1~50):
When you enter the VR BRIGHTNESS mode, it will be no function if you press the BRIGHTNESS KEY. And if
you release the VR knob without any action around 5 seconds, the VR BRIGHTNESS Status bar image will be
closed.
When you enter the “NIGHT MODE” or choose “BRIGHTNESS” Key for brightness adjustment, it will be no
function if you control the VR knob.
When you press “MENU”, “DISP”, “AUTO” Key, you will enter the menu item selection. And the VR
BRIGHTNESS status bar image will be closed.
Any modified or changed parameter setting will be automatically saved if you power off or Exit the
BRIGHTNESS status bar.
NIGHT MODE KEY
When you press the “NIGHT MODE” KEY, the dimming will be down to under 0.5 nit directly. And if you press
“BRIGHTNESS” KEY or “VR” knob at this moment, it will be no function until you press the “NIGHT MODE”
KEY again to release this restriction.
When you press “MENU”, “DISP”, “AUTO” Key, you will enter the menu item selection.
Any modified or changed parameter setting will be automatically saved if you power off or Exit the NIGHT
MODE.
UP / DOWN KEY
It works as menu item selection use, the “UP”KEY can be used as “RIGHT” KEY and the “DOWN” KEY can be
used as “LEFT”KEY.
INPUT KEY
When you press “INPUT” KEY, the screen will pop up the following image:
When you press “MENU”, “BRIGHTNESS”, “AUTO” Key, you will enter the menu item selection.
Any modified or changed parameter setting will be automatically saved if you power off or Exit the menu setting
screen.
Page 26
You can press the “UP”/ ”DOWN” KEY for the menu item selection above. It will
remain at “VIDEO 3” position if you keep pressing “DOWN” KEY to the end. And it
will also remain at “RGB” position if you keep pressing “UP” KEY to the end.
When you press and hold the “INPUT” KEY, the menu screen will show as
.... RGB  DVI . .  VIDEO3  VIDEO2  . .
If you release the “INPUT” KEY for 5 seconds without any action, the menu selection
screen will be closed. And it will remain at the item which you’d selected.