Concord FUSION INSTRUCTION MANUAL User Manual
Page 9
_ USING THE HOOD
You can adjust the hood simply by moving it forwards or backwards.
If you want to remove it completely, first loosen the cover of the hood
by undoing the press-studs and zips. Then pull the hood adaptors (
14
)
simultaFUSIONusly up along the rods.
If you only want to take off the cover of the hood, you can also remove
the rod holding the hood (
02
) out of the hood adaptors (
14
). To do so,
press the release buttons on either side of the hood adaptors (on the
inside) and pull the rod up and out of the adaptors.
Note:
Insert the rod of the hood into the adaptors until it snaps audibly
into place. First close the side press-studs and then the zips. Now
connect the hood to the backrest using the press-studs.
39
_ ADjUSTING THE bACKREST
The backrest can be adjusted seamlessly from the upright position to the
reclining position. To do this, pull the appropriate belt behind the backrest
either upwards or downwards, as required.
38