Concord SLEEPER 2.0 INSTRUCTION MANUAL User Manual
Page 11
• Take the upholstery off the backrest and pass the
shoulder
straps through the slots.
• Pull the mattress and take the upholstery off by opening
the central part.
Wash by hand at a temperature never higher than 30° C.
To refit the cover, follow the same steps in reverse order.
CONCORD SLEEPER can be anchored on any CONCORD
chassis that has the PRO-FIX system.
To fit the safety seat on a chassis, insert the connections
(
06
) in the cavity of the chassis and press until you hear a
click.
To release your CONCORD SLEEPER from the chassis,
press the button (
03
) on the handle (
01
) and pull the seat
upwards.
_ USing yOUr COnCOrD SlEEPEr CArryCOT On THE PUSHCHAir
35
34
Do not expose the cover to sunlight for long periods. When
the seat is not in use, cover it or store it in the boot.
Wash the plastic parts with warm water and soap, carefully
drying all the components afterwards.
The upholstery can be removed for washing.
Follow the instructions below:
• Remove the rubber bands that go underneath the
car seat belt fasteners (
05
) and undo the clasps from the
other.
• Also the plastic flaps that are on the sides of the carrycot.
• Remove the upholstery from the edges of your
CONCORD SLEEPER carrycot.
• Undo the safety harness clasp and pass it through the slot
in the mattress upholstery.
_ mAinTEnAnCE