EVS MulticamLSM Version 10.01 - July 2009 Operating Manual - Manual (Page 20)

EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2009
Issue
10.01.F
11
Function Key Use
• 3 play channels for the 1 s t remote and 1 play
channel for the second remote.
In this configuration, the 1
s t remote can select
PGM+PRV or 3PGM mode and can manage video
transitions. The 2
n d remote is forced to 1PGM mode
and can only handle cut transitions.
F3: 3 Remotes Three Remote Panels are used in the configuration.
F4: 4 Remotes Four Remote Panels are used in the configuration.
F5: Char.
On/Off Enables or disables the on-screen display (Timecode, Clip
ID,…) on the output monitors.
F6: Exit Exits the Multicam software and returns to the EVS Menu.
F7: Clear all
clips Clears all clips. All clips will be lost. A confirmation of this
command is required.
For more information to this action, refer to the section
9.2.12 ‘How to Clear All Non Protected Clips’, on page 49.
Note: This command is not similar to the Clear Video
Disks from the Maintenance menu. If you wish to refresh
completely the server, i.e. to clear all clips including the
protected ones, you need to use Clear Video Disks rather
than Clear all clips.
F8: Stop
Record
Stops the record. The REC key will go off and the F8
function key is now used to restart the record.
F9: Fill Playlist «Dump» feature which allows all clips to be «dumped» at
the end of the current playlist. This allows the operator to
save all material to tape, as a backup feature after a show
is complete. You can select in the Setup menu which
camera angles have to be included in the Fill Play-List
function.
If your clips are currently connected to another server on
the network, the clips from that server will be added to
your current playlist.
Make sure the playlist you have selected is an empty one.
This function will append the clips at the end of an
existing playlist.
Important
In order to guarantee the validity of data and clips previously
saved, it is advised to properly exit the application by pressing
ALT+ Q and ENTER from the keyboard, or F6 and then ENTER from
the Remote Panel. DO NOT TURN OFF THE SYSTEM WHILE THE
APPLICATION IS RUNNING.