EVS XTnano Version 10.04 - January 2011 Operation Manual - Manual (Page 87)

XTnano – Version 10.04 – Operating Manual
EVS Broadcast Equipment SA – January 2011
Issue
10.04.A
79
P
ROCEDURE
To regenerate the timecode in a given playlist, perform the following actions:
1. Activate the TC Regeneration and define the related settings on the Playlist
page (F10), in the blue-highlighted area at the bottom of the page. This
feature is defined for each playlist individually:
2. Activate the internal loop using the SHIFT + Loop keys
3. Roll the playlist.
This will record the playlist back into the recorder channel 1 (CAM A) with
the regenerated timecode.
H
OW TO
A
CTIVATE THE
C
ONTINUOUS
T
IMECODE
R
EGENE
-
RATION
To activate the continuous timecode regeneration, proceed as follows:
1. In the Playlist page (F10), press the TAB key several times until the ‘OFF’
field after ‘Regeneration of TC’ is green highlighted.
2. Press the right arrow key to toggle the function to ‘ON’.
The continuous timecode regeneration function is now active. However, the
timecode will effectively be regenerated when you replay the playlist after
activating a loop. To deactivate the function, press the left arrow on the field to
toggle the function to ‘OFF’.
S
ETTINGS FOR
C
ONTINUOUS
T
IMECODE IN
P
LAYLISTS
The following table describes the various parameters that should be defined when
regenerating the timecode in a playlist:
Parameter Description Possible Values
Continuous in … Specifies whether the timecode
should be continuous for the whole
playlist or for each playlist element.
PLST, CLIP
From … Specifies the initial TC value to be
used for the timecode regeneration Timecode, LTC TC,
User TC
In … Specifies the TC type in which the
timecode should be regenerated LTC or VITC in SD
HANC VITC, HANC
LTC or both