EVS XTnano Version 10.04 - January 2011 Operation Manual - Manual (Page 95)

XTnano – Version 10.04 – Operating Manual
EVS Broadcast Equipment SA – January 2011
Issue
10.04.A
87
9.15.5 H
OW TO
P
ERFORM A
R
EPLACE
You first define the Replace function in the Replace Edit mode. Then, you execute
the Replace function in the Replace Playback mode.
To perform a Replace, proceed as follows:
1. Open the playlist in which you want to replace a section in Playlist Edit
mode.
2. In Playlist Edit mode, press Menu on the Remote Panel to access the
secondary menu.
3. Press the A key to enter the Replace Edit mode.
4. Use the jog dial to reach the desired IN point for the Replace section and
press the IN key to mark it.
When the IN point has been marked, the display switches to:
Cam A + 0field
Replace Int.Loop Ext.Loop
The Int.Loop (B) and Ext.Loop (C) keys are blinking.
5. If you want to specify the OUT point for the Replace section at this stage,
jog to the requested point and press the OUT key. Otherwise, you can define
the OUT point while you perform the Replace.
6. Press the B or C key to select whether you will use the internal loop or
external loop to perform the Replace.
For more information on the loop type and additional parameters, refer to
the section ‘Loop Mode in the Replace Function’, on page 88.
The playlist is cued before the IN point (to create guardbands), ready to be
initiated.
A flashing message appears on Remote: “Start Replace : lever
o r p l a y b u t t o n
”.
7. Push the lever or press the Play key on the Remote Panel to shift to the
Replace Playback mode and start the Replace process.
8. If you have not defined the OUT point for the Replace in step 5, press the
OUT key when you reach the desired OUT point.
While the Replace is being performed, the following messages are displayed
on the OSD:
“Replace in Progress”
“Clipping guardbands”
“Replace by clip xxx”
On the Remote Panel, a confirmation message pops up:
Replace in/out by clip xxx
[MENU] : Cancel [ENTER]: Confirm