EVS XTnano Version 11.01 - November 2012 Configuration Manual - Manual (Page 58)

Editing Commands
The following table presents the commands to edit the configuration settings in the
Multicam Configuration window when the field has been selected (using the TAB key).
In text fields, you can directly type the requested value for a selected field.
Command description Command key
Increasing the value
(or displaying the next value in the list) SPACEBAR
Decreasing the value
(or displaying the previous value in the list) SHIFT+SPACEBAR
Moving the cursor position within a text field SHIFT+ RIGHT ARROW /
LEFT ARROW
Resetting the value of the selected setting F5
Resetting all values of all settings in the current tab
for the selected configuration CTRL+F5
Resetting all values of all settings in all tabs for the
selected configuration CTRL+SHIFT+F5
Applying changes ALT+A
Leaving without applying changes ESC, ENTER
Enabling Values in a List
For some settings, you need to enable values in a list of displayed values. This is, for
example, the case with the selection of pages (receive pages, protect pages) in the
Operation tab.
The enabled pages are highlighted in blue, and the disabled pages are not highlighted.
To enable a list of values for a given setting, proceed as follows:
1. Select the list of values with the TAB key.
Once the list of values is selected, the enabled values stay highlighted in blue, and the
disabled values are highlighted in pink.
2. On the keyboard, type the page numbers you want to enable. They become
highlighted in blue.
3. Apply the changes with ALT+A, and confirm the action.
XTnano Server - Version 11.01 - Configuration Manual
3. Multicam Configuration 48