Codec availability, Codec-related information, Genlock – EVS XTnano Version 11.01 - November 2012 Configuration Manual User Manual
Page 82: Codec availability depending on license codes
Genlock
Description
Specifies the type of genlock signal, the status and the frame
synchronizer mode.
Values
Type: 'Blackburst' or 'Tri-Sync' (always 'Blackburst' in SD)
Status: 'OK' or 'BAD' (defined by the EVS server)
Mode: 'Studio' (no correction of a shifted video signal) or
'Resync' (resynchronization of a shifted video signal)
Codec Availability
Codec Availability Depending on License Codes
The following table presents the codec availability for an XTnano server depending on the
license code. 'Yes' in the Available column means the codec (and the related license
code) is available by default:
Codec
V3X Codec
Board
COHX Codec
Board
SD
DVCPro 50
with code 9
with code 9
HD
DVCPro HD
with code 8
with code 8
Note
On servers equipped with a COHX board, the codecs availability depends on the
board type (COHX SD, COHX HD, or COHX SD/HD).
Codec-Related Information
Bitrates and Recorded Lines in SD 525i / 625i
SD 525i
SD 625i
Codec Type
DVCPro 50
Bitrate
50 Mbps
Default bitrate
50 Mbps
Recorded video lines
480 lines
(L23-262; L285-524)
576 lines
(L23-310 ; L335-622)
XTnano Server - Version 11.01 - Configuration Manual
3. Multicam Configuration
72