Automake clip for cam a/b/c/d/e – EVS XT3 Version 11.00 Configuration Manual User Manual
Page 189
The following screenshot presents pages 1 and 2 of the Operation tab in the server-based
application, where the Clips settings are available, and highlights the Clips settings area:
Automake clip for CAM A/B/C/D/E
Introduction
When creating clips, the clip corresponding to the camera on
which IN/OUT points have been marked are always saved. It
is possible to save automatically the same action on the other
cameras.
Only cameras letters applicable to the logical channels are
displayed.
This parameter is only available in the Multicam LSM, Replay-
Only LSM and XSense configurations.
Description
Specifies that clips have to be created on the given camera (A,
B, C, D or E) even if no IN or OUT point has been marked on
that camera.
Values
Yes / No
Default value
Yes
183
3. Multicam Configuration
EVS Broadcast Equipment S.A. - April 2012
Issue 11.00.C