EVS XT3 Version 11.00 Configuration Manual - Manual (Page 32)

How to Set the System Date and Time
To set up the system date and time from the Multicam Setup window, proceed as follows:
1. In the Multicam Setup window, press T to call the System date and time command.
The following window opens:
2. In this window, type:
◦ the date in the DD/MM/YYYY format
◦ the time in the hh:mm:ss format (24-hour display)
using TAB to move from one field to the other.
3. Press ENTER to apply the changes to the system date and time.
The date and time you have entered here will automatically be taken into account when
you launch a configuration.
2.3.6. Setting the Default Output To VGA/Video
Introduction
Between the PC boot and the I/O boot, the video driver is loaded. The Default Output to
VGA/Video command allows you to switch the video display from and to one of the
following modes:
• VGA mode
• B&W video mode. This mode sends a video CVBS output on the VGA connector,
which allows the VGA screen to be displayed on a standard composite video monitor
using the VGA <==> BNC adapter provided with the unit.
Note
When a configuration has been launched, you can still switch from one mode
to the other with ALT + BACKSPACE.
How to Change the Default Output
By pressing E, the shortcut key to the Default Output command, the default output will
automatically toggle from one mode to the other.
The parameter displayed on the Multicam Setup window corresponds to the active value.
This means that when the parameter displayed is 'Default to VGA', the active mode is the
VGA mode.
XT3 Server - Version 11.00 - Configuration Manual
2. Multicam Setup 26